Sulky RS 350 - 1000 - Manual (Page 49)

RS Centrifugal Spreader.................................................................................................................................................... Page 47
For the hydraulic drive:
- Connect the hydraulic hoses to the corresponding hydraulic connectors
on the towing vehicle, in compliance with the markers (red = pressure,
blue = return).
Mounting and removal should only take place when the spreader is
stopped.
DANGER OF INJURY DUE TO ROTATING PARTS
4.3.Dismantling
- Lower the spreader onto a fixed, flat surface.
- Place the hydraulic lift in the floating position.
- Turn off the towing vehicle engine and put on the handbrake.
- If necessary unscrew the hydraulic pipes or the universal joint.
For the 3-point assembly:
- Unscrew the pin with drop side ring on the bottom arms and remove
these from the linkage eye-bolts.
- Unscrew the pin with drop side ring on the third point and take it off.
For the fixed mounting with support truck:
- Take off the screws at the top and the nuts at the bottom and uncouple
the spreader.
- Secure the uncoupled spreader so that it does not tip over!
Assembly and dismantling