Sulky RS 350 - 1000 - Manual (Page 48)

RS Centrifugal Spreader.................................................................................................................................................... Page 46
4.2.Mounting on the towing vehicle
Mounting should only be carried out by trained, qualified personnel.
Move the towing vehicle up to the machine.
For the 3-point assembly:
- Lower the bottom arms to the mounting height.
- Place the hydraulic lift in the floating position.
- Turn of the tractor engine!
- Connect the bottom arms onto the spreader chassis bolt and secure it
with the pins with drop side rings.
- Align the spreader with the middle of the spreading vehicle.
- Fix the third point and secure it with the pins with drop side rings.
For the fixed mounting with support truck:
- On the spreading vehicle fix the support truck supplied to the points in-
tended for this.
- Then fix the spreader on the support truck with the 2 screws at the top
and the 2 bolts at the bottom and secure with pins with drop side rings.
For the drive by power take-off:
- Then check the length of the universal joint (for this also see the operating
instructions for the universal joint):
- Measure between the edge of the towing vehicle power take-off and the
start of the gear unit connection.
- Then take off about 30 mm from the measurement noted and shorten the
universal joint accordingly. Connect the articulated shaft and check that
this still has free space in the sliding area during lifting and lowering of
the spreader. Ensure that the universal joint is at the stop on both sides or
that it is secured by an adjustment screw.
Assembly and dismantling