List of the parameterising functions – Waldmann PULSE PIR version IV - with MFT, Typ II User Manual
Page 14
14
Operating Manual Light Control „PULSE HFMD / PULSE PIR - Vers. IV“
ENG
List of the parameterising functions
Note:
The functions written in
blue
are not active in all versions. Please note the explanations of the func-
tions on the following pages.
Fig. 3
LED 1 2 3 4 5 6
Fig. 6
Key I
Light
bar
Key II
The following functions can be selected:
The bold-printed values are the in-factory defaults
Level
Function
Light bar (Fig. 6)
Designation
1
Funct. 1.1:
LED 1 (dark green)
Light bar ON/OFF
1
Funct. 1.2:
LED 2 (light green)
External switching ON/OFF
1
Funct. 1.3:
LED 3 (yellow)
Burn-In function ON/OFF
1
Funct. 1.4:
LED 4 (orange)
Write protection ON/OFF
1
Funct. 1.5:
LED 5 (light red)
Light control ON/OFF
1
Funct. 1.6:
LED 6 (dark red)
Presence control ON/OFF
1
Funct. 1.7:
LED 6+5
Demo mode ON/OFF
2
Funct. 2.1:
LED 1 (dark green)
Sensitivity high ON/OFF
2
Funct. 2.2:
LED 2 (light green)
Automatic switch-on ON/OFF
2
Funct. 2.3:
LED 3 (yellow)
Special function ON/OFF
2
Funct. 2.4:
LED 4 (orange)
Sensor LED ON/OFF
2
Funct. 2.5:
LED 5 (light red)
Continuous mode ON/OFF
2
Funct. 2.6:
LED 6 (dark red)
Parameter setting protection ON/OFF
2
Funct. 2.7:
LEDs 6+5
Special function ON/OFF
3
Funct. 3.1 - 3.6:
LEDs 1-6
Follow-up time 5, 10, 15,20, 25, 30 min
4
Funct. 4.1 - 4.6:
LEDs 1-6
Range 10, 20, 40 ,60, 80, 100 %