Waldmann PULSE PIR version IV - with MFT, Typ II - Manual (Page 27)

27
Operating Manual Light Control „PULSE HFMD / PULSE PIR - Vers. IV“ ENG
Loading setting level 2
Actuation Display
Light bar LED 1 (dark green)
Parameterisation mode ON
Function 2.4 Sensor LED
Light bar LED 4 (light green)
Function 2.4
Changing the function from ON to OFF or vice versa
Setting function 2.4
LED changes from constantly lit
to flashing or vice versa:
- constant = Function ON
- flashing = Function OFF
Press key II 3 times
Loading the parameterisation mode
Light bar LEDs 1+2
Level 2
Press both keys again
for 5 seconds
Sensor LED
Function for switching both LEDs
in the operating unit sensor on and
off (see Fig. 4).
By default, the function is set to
"OFF", i.e., the LEDs in the light
head are off.
For lights without column operating
unit, the function is set to "ON".
If the function is on, the LEDs in
the light head are lit in addition to
the light bar display.
The function can be changed on
- Lights equipped with HFMD
sensor
- Lights equipped with PIR sensor
Press both keys
for at least 10 seconds
3 x
n x Press key I as often as
necessary for reaching
the desired value