Wasp Barcode WaspLabeler +2D User Manual - Manual (Page 114)

110
Wasp Labeler User Manual
3. Enter the beginning character in the Start at seed: field, then enter
how many characters you want to increase per a set number of
labels in the Step and Every fields. For example, the default
settings (shown in the screen shot above) sets the serialization to
start at letter A and increase one letter (step) every one label. So
each label will go up one level. Changing the Every field to 2 means
that the alpha serialization will increase one letter (step) every 2
labels.
4. By default the serialization continues past Z to AA, BB, etc.. If you
want to change this, select the Rollover after checkbox and enter a
value. After the entered value is reached (the default is Z), the
serialization will start over with the seed value.
5. If you set the labels to rollover after a set value and do not want
them to reset to the seed value, select the Reset after rollover
checkbox. Enter the value you want to restart at in the field
provided.
6. In the Serialization Configuration section, check the checkbox if
you want to do one of the following:
- increment the sequence with each new record in an external data
source, or
- resume the serialization where it left off at the next printing.
7. Click the Preview button to view how your serialization will look.
Below is an example of the Serialization Preview screen:
8. By default 100 samples are displayed. You can adjust this number
up or down using the Number of samples to display field arrows or
enter a sample number. Click the Refresh button to update the
samples with any changes you have made or Close to close the
Serialization Preview screen.
9. Click OK on the Serial Alpha screen to save your changes.