Wasp Barcode WaspLabeler +2D User Manual - Manual (Page 69)

65
Wasp Labeler User Manual
3.3.2 Picture Properties Box: Format Tab
The Format tab allows you to specify an exact location for a selected barcode on your label. You can
also enter precise height and width measurements on this tab. Below is an example of the Format tab.
The Format tab is divided into two sections, General and Picture.
Format Tab - General Options are:
• Left - Enter the precise location you want your barcode relative to the left side of the label.
• Top - Enter the precise location you want your barcode relative to the top of the label.
• Width - Enter the width of your text box.
• Height - Enter the height of your text box.
• Rotate - Rotate the text box on your label.
• Display on Print - Make sure this checkbox is selected if you want the text box to display when
your label is printed.
• Anchor - Select where you want to anchor the object on the page. For example, if you set the
Anchor for the image to Top, then adjust the Height, the Top will stay in the same position and
the picture will "grow" from the bottom. If you anchor it Center, the center position will stay the
same and the picture will "grow" from the top and bottom.