Wasp Barcode WaspLabeler +2D User Manual - Manual (Page 64)

60
Wasp Labeler User Manual
2. You can move the drawing object by clicking on it and dragging it. Resize the object by clicking
on a corner of the object and dragging it. You can also enter precise size and location
coordinates in the Properties Box > Format tab. Options are:
• Object Name - You can optionally enter a new name for the object here.
• Left - Enter the precise location you want your barcode relative to the left side of the
label.
• Top - Enter the precise location you want your barcode relative to the top of the
label.
• Width - Enter the width of your text box.
• Height - Enter the height of your text box.
• Rotate - Rotate the text box on your label.
• Display on Print - Make sure this checkbox is selected if you want the text box to
display when your label is printed.
• Anchor - Select where you want to anchor the object on the page. For example, if
you set the Anchor for a box to Top, then adjust the Height, the Top will stay in the
same position and the box will "grow" from the bottom. If you anchor it Center, the
center position will stay the same and the box will "grow" from the top and bottom.