Western Digital My Net Wi-fi Range Extender User Manual - Manual (Page 12)

GETTING STARTED
9 MY NET WI-FI RANGE EXTENDER
USER MANUAL
3. If the router has a WPS or icon button:
a. Press the router’s WPS button and the extender’s WPS button within a period of two
minutes.
b. Make sure:
The wireless LAN LED blinks while the connection is being established.
When the wireless connection between the router and the extender is established,
the wireless LAN LED is solid, and the wireless signal strength indicator is on.
The router and extender are connected wirelessly.
c. Congratulations! You can start using the extender in conjunction with the router, or if
you want to configure the extender’s settings, proceed to “Configuring Your
Extender After Initial Setup” on page 11.
4. If the router does not have a WPS button or WPS is disabled:
There are cases requiring you to set up the extender manually, for example, when:
Wi-Fi Protected Setup (WPS) is disabled.
The router does not support WPS.
Some interference is preventing WPS from working.
SSID broadcast is disabled.
WPA only is enabled.
WEP is enabled.