Yamato Scientific BH500 Thermo-Elite - Manual (Page 10)

7
Precautions in handling
10. Do not sprinkle water on the control part and the operation panel
•
When water splashes to an internal electrical component, the leak and the electric shock
may be caused.
•
Do not touch the upper surface in the reservoir when working at the high temperature.
Failure to observe this caution may cause scald.
11. Confirmation of safety
•
Turn on the earth leakage breaker.
•
Pour the liquid (water) into the reservoir tank.
•
Water level should be 3 ∼5 cm below the upper
edge. When circulated at a distance, the water
level will go down. Pour the water again into the
reservoir to be a fixed water level.
•
Be sure whether independent tempera-ture
overheating prevention device is set in a
temperature which is 15
℃ or more higher than
the temperature of the tank used. (BH500)
•
Stabilize by using stopper in the bottom in the
reservoir when you use the throw type cooling
device together.