Yamato Scientific BH500 Thermo-Elite - Manual (Page 38)

35
About attached goods outside the standard
attention :
Request the following options when you place an order of Thermo Elite. After
installation the order for these options cannot be accepted.
5. Digital printer OBH60
OBH 60
„ The following information can be printed out by using Digital Printer OBH60.
Character Record Mode
•
Measured Temperature
•
Set point
•
Wait state
•
Strength of pump
•
Alarming state
•
Accumulated time
•
Time of the record
Graphic Record Mode
The measured temperature of the liquid in the reservoir is recorded by the time based graph.
Immediate Date Record Mode
The information at desired time can be recorded. The contents of the information is the same as
that of Character Record Mode.
„ When the main body of the equipment detects abnormality, information when generated abnormally
is printed.
„ When the power supply is intercepted due to the power failure etc. , the date, the time of the
intercepted point, and the date and the time of the returning point are printed immediately after the
power supply return.
6. Independent temperature overheating prevention device
(BH500 is equipped normally)
OBH 50
„ The equipment is independent safety device besides the one built into the controller. Double safety
measures can be considered.
Range of temperature setting Range of temperature setting Range of temperature setting Range of temperature setting : 0∼399℃ 3-digit digital switch
Sensor
Sensor Sensor Sensor : K-thermocouple (Control sensor : Double sensor stored in the same protection tube as
Pt100
Ω
)
to Thermo Elite
to AC100V