Rockwell Automation 20B PowerFlex 700 Power Jumpers - Manual

Publication 20B-IN021B-EN-P
The PowerFlex 700 drive contains protective MOVs and Common Mode
Capacitors referenced to ground (see below). To guard against unstable
operation and/or damage, the drive must be properly configured as shown in
Table A on page 2 .
Important: All PowerFlex 700 drives are shipped with the DC bus common
mode capacitors referenced to ground.
The information in this document supersedes the MOV and Common Mode
Capacitor material in the following:
For additional general information, refer to:
Before proceeding, ensure that all power to the drive has been removed.
Title Publication
PowerFlex 700 Vector Control User Manual 20B-UM002C
PowerFlex 700 Standard Control User Manual 20B-UM001G
PowerFlex 700 Installation Instructions - Frames 0…6 20B-IN019A
PowerFlex 700 Installation Instructions - Frames 7…10 20B-IN014E
Title Publication Available Online at …
PowerFlex 700 Vector Control User Manual 20B-UM002 www.rockwellautomation.com/
literature
PowerFlex 700 Standard Control User Manual 20B-UM001
Wiring and Grounding Guidelines for PWM AC Drives DRIVES-IN001
Guarding Against Electrostatic Damage 8000-4.5.2
!
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection guide.
R/L1
S/L2
T/L3
DC+
DC–
MOV and AC EMI Capacitor Phase to Ground Common Mode Capacitor to Ground
Jumper-Wire
Jumper-Wire
PowerFlex 700 Power Jumpers
Installation Instructions