Rockwell Automation 20D-RES-A0 PowerFlex 700S Resolver Feedback Option - Manual (Page 5)

Resolver Feedback Option Card for PowerFlex® 700S Drives 5
Step 2: Removing the
Control Assembly
(if necessary) This step is necessary only when another drive or panel component blocks
access to the control assembly. Avoid removing it if possible.
Step 3: Removing the
Feedback Option Card
Task Description
Unplug I/O and SynchLink cables from the main control board, unplug feedback wiring
from feedback option feedback option card, and unplug communication cables from
DriveLogix controller
Unplug ribbon cable
Remove M5 nuts
Remove control assembly
A
B
C
D
C
D
B
Proper tightening
torque for reassembly
is 18 lb.-in.
Task Description
Remove screws
Remove feedback option board and through-board pin connectors from main control board
Remove standoffs from main control board (on Phase I drive only)
A
B
C
C
B
Note: Phase I shown.
A