Rockwell Automation 20D-RES-A0 PowerFlex 700S Resolver Feedback Option User Manual
Page 6
6
Resolver Feedback Option Card for PowerFlex® 700S Drives
Step 4: Installing the
Feedback Option Card
Phase I Drives
Important: Do not use a screwdriver to pry the P1 terminal plug from the
circuit board. This may damage the plug.
Task
Description
Remove the terminal block P1 from the Resolver Feedback option card
It is much easier to remove before the card is installed
Install and tighten stand-offs (min/max 7 in-lb / 10 in-lb)
Insert short pins of through-board pin connectors into mating connectors on the main
control board
The end with short pins must plug into the main control board
Plug mating connectors of Resolver Feedback option card onto long pins of through-board
pin connectors
The end with longer pins must plug into the Resolver Feedback option card
Secure card to stand-offs, using screws with captive lock washers, tighten screws with
phillips screwdriver (min/max 6 in-lb / 8 in-lb)
A
B
C
D
E
The end with longer pins must
plug into the Resolver Feedback
option card
The end with short pins must
plug into the main control board
C
D
E
B
C
D