Rockwell Automation 20D DriveLogix Controller for PowerFlex 700S Phase I Drives - Manual (Page 2)

2 DriveLogix Controller for PowerFlex 700S Phase I Drives
What You Need To Do To remove an existing DriveLogix controller from the drive:
❑ Step 1: Remove power from the drive
❑ Step 2: Remove the covers from the Control assembly
❑ Step 3: Remove the existing DriveLogix controller assembly
❑ Step 4: If necessary, remove the Communication Daughter card
To install a new DriveLogix controller on the drive:
❑ Step 5: If necessary, install the Communication Daughter card
❑ Step 6: Connect the battery
❑ Step 7: Install the stacker connectors
❑ Step 8: Install the new DriveLogix controller assembly
❑ Step 9: Complete the Installation of the DriveLogix Controller
❑ Step 10: Connect the controller to a device
❑ Step 11: Install the drive covers
Additional Information
•
Monitor the DriveLogix Controller LEDs
•
DriveLogix Controller Specifications