Rockwell Automation 20D DriveLogix Controller for PowerFlex 700S Phase I Drives - Manual (Page 5)

DriveLogix Controller for PowerFlex 700S Phase I Drives 5
Step 3: Removing the
Existing DriveLogix
Controller Assembly
If there is no Communication Daughter card installed in the DriveLogix
Control assembly, continue with Step 6:
Connecting the Battery on page 8 .
If a Communication Daughter card is installed in the DriveLogix Control
assembly, continue with Step 4:
Removing the Communication Daughter
Card on page 6 .
Task Description
Remove any existing communication cables from the
DriveLogix Controller assembly.
Loosen the M3 hex-nut.
Remove the two M3 screws.
Remove the DriveLogix Controller assembly from the drive.
A
B
C
D
C
D
B