Ce compliance, Appendix, European communities (ec) directive compliance – Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual User Manual
Page 148: Emc directive
Rockwell Automation Publication 193-UM011A-EN-P - September 2010
149
Appendix
C
CE Compliance
The EC4 Current Monitoring Relay is intended for use in a heavy industrial
environment. It is CE marked for conformity to the Low Voltage Directive
73/23/EEC (as amended by 93/68/EEC), the EMC Directive 89/336/EEC (as
amended by 92/31/EEC and 93/68/EEC), and the ATEX Directive 94/9/EC,
when installed as described in this manual.
European Communities (EC)
Directive Compliance
To obtain a copy of the EC4 Current Monitoring Relay’s Declaration of
Conformity (DoC), contact your local Allen-Bradley distributor or go to
http://www.ab.com/certification/#CEmark.
EMC Directive
This product is tested to meet Electromagnetic Compatibility (EMC) Directive
89/336/EC, as amended by 92/31/EEC and 93/68/EEC, by applying the
following standards (in whole or in part), and as documented in a technical
construction file:
• EN 60947-4-1 – Low Voltage Switchgear and Control Gear; Part 4 –
Contactors and Motor Starters, Section 1 – Electromechanical Contactors
and Motor Starters
• EN 60947-5-1 – Low Voltage Switchgear and Control Gear; Part 5 –
Control Circuit Devices and Switching Devices, Section 1 –
Electromechanical Control Circuit Devices
IMPORTANT
The conformity of the EC4 Current Monitoring Relay to these standards
does not guarantee that an entire installation will conform. Many other
factors can influence the entire installation and only direct measurements
can verify total system conformity. It is therefore the responsibility if the
installer to ensure system conformity.
IMPORTANT
The grounding requirements specified in this manual must be followed
by the installer in order for the product to comply with the EMC
directive.
ATTENTION: This is a Class A (heavy industrial) product. In a
Class B (light industrial or domestic) environment, this product
may cause radio interference, in which case the installer may be
required to take additional measures to mitigate it.