Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual - Manual (Page 84)

Rockwell Automation Publication 193-UM011A-EN-P - September 2010 85
Current Monitoring Parameters Chapter 6
L2 CURRENT
This parameter provides the L2 phase current
measurement in amperes.
Parameter Number 2
Access Rule Get
Data Type INT
Object Mapping 2C
hex
-1-232
2C
hex
-1-9
2C
hex
-1-228
Group Monitor
Units Amps
Minimum Value See Table 20 -
Maximum Value See Table 20 -
Default Value None
L3 CURRENT
This parameter provides the L3 phase current
measurement in amperes.
Parameter Number 3
Access Rule Get
Data Type INT
Object Mapping 2C
hex
-1-233
2C
hex
-1-10
2C
hex
-1-229
Group Monitor
Units Amps
Minimum Value See Table 20 -
Maximum Value See Table 20 -
Default Value None
GF CURRENT
This parameter provides the ground fault
current measurement in amperes.
Parameter Number 10
Access Rule Get
Data Type INT
Object Mapping 2C
hex
-1-110
Group Monitor
Units Amps
Minimum Value 0.00
Maximum Value 12.75 (approx.)
Default Value None