Rockwell Automation W-Series Brushless Servo Motor - Manual (Page 3)

W-Series Motor Installation Instructions 3
Publication 1398-IN520A-EN-P — May 2001
Before You Install the Motor
Before installing or storing the motor:
1. Remove the motor carefully from its shipping container.
2. Visually inspect the motor for any damage.
3. Examine the motor frame, front output shaft, and mounting pilot for
any defects.
ATTENTION
!
Do not open or attempt to open the motor while power
is applied to the motor.
Only a qualified Allen-Bradley employee can service this
type of motor. However, the user can access the power
and feedback connectors by removing the back cover.
Failure to observe these safety procedures could result
in personal injury or damage to equipment.