Rockwell Automation 1201 GRAPHIC PROGRAM TERM 3.XX - Manual (Page 16)

Chapter 2
Parameter Option
2–3
With the Linear Parameter Screen (Figure 2.5) displayed, perform the
following steps:
Step 1 Use the
or key to scroll through the
parameter numbers; or
Step 2 If you wish to enter a parameter number directly, press the
F2
soft designator key. The dialog box shown in Figure
2.5 will appear.
Figure 2.5
Linear Direct Access Screen
Linear: [ ]
Auto Tune Speed
Auto Tune I Limit
Not Used
Not Used
Par
Enter Parameter :
< >
Min : 1 Max 497
Step 3 Use the numerical keys F
9
& PRESET 2
0
to enter a
parameter number within the cursors (Figure 2.6).
Figure 2.6
Parameter Number Entry
Enter Parameter :
<
90
>
Min : 0 Max 497
Press to enter your selected Linear Parameter number. The
information on your selected parameter (90 in this case) will appear as shown
in Figure 2.7.
If you press without entering a parameter number (no digits), the
display will return to the previous parameter. Toggling between 2 parameters
is allowed (Present & Previous).
Accessing a Parameter
in the Linear Mode