Rockwell Automation 1201 GRAPHIC PROGRAM TERM 3.XX - Manual (Page 4)

1
Chapter
1–1
Introduction
Chapter 1 describes the various controls and indicators found on the optional
Graphics Programming Terminal (1201 GPT). The GPT is an enhanced
control that provides a means of programming, viewing operating
parameters, on-line troubleshooting and analyzing of all SCANbus
TM
products.
When an optional GPT (Figure 1.1) is supplied, it will be either mounted to
the front of a Drive as a panel mount terminal or supplied as a remote device
with a 1.8 meter (6 foot) long cable. The GPT offers a 40 by 8 character
display that can also be used as a graphics display to show bartype graphs,
etc.
Figure 1.1
1201 Graphics Programming Terminal
B
5
PRESET 1 PRESET 3
D
7
E
8
F
9
A
4
C
6
ALT PRESET 4
1
XREF 1
3
ESC
PRESET 5
2
PRESET 2
0
JOG
F1 F2 F3 F4
NOTE: This manual shows examples based on a 1336 FORCE TM Drive using a
PLC Comm Adapter Board. On other SCANbus products or 1336T drives equipped
with other adapter boards, some options may not be active or displays may vary
slightly from the examples shown here.
1336 FORCE and SCANbus are trademarks of Allen–Bradley Company, Inc
Chapter Objectives
GPT Description