Rockwell Automation 1608M MegaDySC User Manual, 800 - 2400 A - Manual (Page 25)

Rockwell Automation Publication 1608M-UM002A-EN-P - September 2013 25
Chapter
6
Display Screen
Overview The MegaDySC touch screen display is a window to voltage sags and DySC
protection. The display provides system status, voltage sag notification and
history, runtime statistics and system history in a simple and intuitive touch-
based user interface.
Quick Start At commissioning time perform the following steps to configure your system.
Note: The touch screen is optimized for use with a plastic stylus or bare finger.
When the system first starts, the “HOME” screen is displayed.
Step 1: Press the “Configuration” button at the top of the screen (See Figure 8 ).
Figure 8 - Quick Start
Step 2: Set date and time by pressing “Set System Clock” on the left side of the
screen (See Figure 8 ).
Step 3: Use the left/right arrows under “System Clock” to highlight each
component. Use the plus (+) and minus (-) buttons to set the correct time and/or
date.