Rockwell Automation 1756-L72EROMS Armor GuardLogix Controller - Manual (Page 16)

16 Armor GuardLogix Controller
Rockwell Automation Publication 1756-IN060B-EN-P - November 2013
Set the Network IP Address with the Logix Designer application
Follow these steps to use the Logix Designer application to set the module’s IP address.
1. In the Controller Organizer, right-click the EtherNet/IP module and choose Properties.
2. On the Module Properties dialog box, click the Port Configuration tab.
3. In the IP Address field, type the IP address.
4. In the other fields, type the other network parameters, if needed.
5. Click Set.
6. Click OK.
IMPORTANT The fields that appear vary from one EtherNet/IP module to another.