Rockwell Automation 1756-L72EROMS Armor GuardLogix Controller - Manual (Page 21)

Armor GuardLogix Controller 21
Rockwell Automation Publication 1756-IN060B-EN-P - November 2013
not corrupt, or preform the procedure prior to downloading any project to your Armor
GuardLogix controller.
Follow these steps to create the recovery memory card.
1. Update the Armor GuardLogix controller to the desired firmware revision by following
the instructions in Update the Controller on page 17 .
2. Remove the memory card that shipped with the controller by following the instructions
in Remove and Install the SD Card on page 8 .
3. Insert a new 1784-SD1 card.
4. Load a blank project into the controller making sure to check the box to store the project
to the memory card and load on power-up.
5. Remove the ‘recovery’ memory card, store it in a secure location.
6. Re-insert the memory card that shipped with the Armor GuardLogix controller by
following the instructions in Remove and Install the SD Card on page 8 .
Follow these steps to use the recovery memory card to recover the controller.
1. Remove the memory card that shipped with the controller.
2. Insert the recovery memory card.
3. Cycle power to the controller.
The blank project on the recovery memory card overwrites the project in the controller.
IMPORTANT To avoid inadvertently over-writing your application program, you must not use the 1784-SD1
memory card that shipped installed in the Armor GuardLogix controller.
TIP Label this memory card ‘recovery’, so that you do not confuse it with the memory card that
shipped with the controller.