Rockwell Automation 1792D-CBXXX ArmorBlock MaXum I/O Cable Bases Series B - Manual (Page 3)

ArmorBlock MaXum I/O Cable Bases Series B 3
Publication 1792D-IN009B-EN-P - September 2000
Install Your ArmorBlock 1792D-CB12
To install the cable base:
• Mount the cable base
• Attach the module to the base
• Attach the cables
These steps are described in more detail in the following
sections.
Mount the Cable Base
The cable base can be mounted either vertically or horizontally, using
3 screws. Cable bases accommodate 4 or 8 point ArmorBlock MaXum
modules. You must allow additional space for installation of 8 point
ArmorBlock MaXum modules. They are longer than the 4 point
modules.
41537
When
installing a
cable base
with an 8
connector
module, allow
for the
additional
length.
1.90in.
48.18mm
2.70in.
68.5mm
1.42in.
36.0mm
0.26in.
6.5mm
4.21in.
107mm
5.71in.
145mm
1.35in.
34.18mm 1.10in.
28mm
2.05in.
52mm
0.18in.
04.6mm
1.10in.
28mm
0.60in.
15.3mm
5.71in.
145mm
4 connector
pins
1.24in.
31.5mm
7.84in.
199mm
7 connector
module
12mm