Rockwell Automation 1792D-CBXXX ArmorBlock MaXum I/O Cable Bases Series B - Manual (Page 8)

8 ArmorBlock MaXum I/O Cable Bases Series B
Publication 1792D-IN009B-EN-P - September 2000
The cable, with the end cap applied, must end between the two lines
on the cable base, as shown below.
IMPORTANT
You must apply end caps to cables that end at the
base prior to installation. The caps seal the cables.
The cable, with the end cap applied, must end
between the two lines on the cable base as shown
below. When Auxiliary Power is not used, seal
both openings to the power slot. See specific
instructions on page 10.
End cap
30827-M
The cable must end between these two lines. The clear end cap
allows you to see the cable position.
Apply End cap
prior to installing
cable.
If a power cable is not
used, seal the cable
slots. Place the two
end caps in the slots
to seal them. Pass through