Rockwell Automation 1792D-CBXXX ArmorBlock MaXum I/O Cable Bases Series B - Manual (Page 9)

ArmorBlock MaXum I/O Cable Bases Series B 9
Publication 1792D-IN009B-EN-P - September 2000
Attach the Flat Media Cables
The KwikLink DeviceNet flat media cable is a four-conductor cable. It
has a key design feature that allows it to “seat” in the cable base in
only one direction. Labels indicate which slot to use for the Auxiliary
Power and DeviceNet connection.
To attach the flat media cable use the steps listed in the following
graphic.
POWER
NETWORK
30829-M
41530
5. Snap the gray DeviceNet
cable into the slot labeled
NETWORK.
POWER and NETWORK labels indicate Auxiliary
Power and DeviceNet cable placement.
End cap storage
(2 caps are provided)
1. Remove the end cap
covers from the storage
area. These are used to
cover the cables when they
end.
2. Apply an end cap to cables
that end at this point in your
network. End caps cannot be
applied after the cables are
attached to the base.
3. Align the keying features of
the cable and base. The cable
and cable slots are angled. The
cables can only be placed in one
direction.
4. Modules with outputs require
an Auxiliary Power cable. If the
module you use has outputs,
snap the black power cable into
the slot labeled POWER.