Rockwell Automation 1785-Lx0E Ethernet PLC-5 Programmable Controllers Installation Instructions - Manual (Page 7)

Publication 1785-IN063B-EN-P - January 2006
Ethernet PLC-5 Programmable Controllers 7
New Features
The controllers contain an RJ-45 connector for the Channel 2 communication
port.
The controllers provide additional Channel 2 port configuration and status:
• BOOTP, DHCP, or Static entry of IP address
• Auto Negotiate speed selection
• Full/Half Duplex port setting
• 10/100 speed selection
• Email client functionality
• Enable/Disable HTTP Web Server
• Enable/Disable SNMP functionality
To see or activate the new configuration and status features:
1. Open or create a project in RSLogix 5 software, version 7.1 or later.
2. Click on the Channel Configuration menu.
You see the Edit Channel Properties menu.
3. Click on the Channel 2 tab.
BOOTP, DHCP, or Static Entry of IP Address
As shown in the following screen capture, you can select between a static or
dynamic network configuration.
• The default is Dynamic Network Configuration Type and
Use BOOTP to obtain network configuration.
• If you choose a dynamic network configuration, you can change the
default BOOTP to DHCP.
• If you choose a static network configuration type, you must enter the IP
address.
STAT
100M
10M
ENET Status
ENET Transmit
RJ45
Connector