Rockwell Automation 1751 SynchLink 4-Port Splitter Block Installation Instructions - Manual (Page 4)

4 SynchLink 4-port Splitter Block
Publication 1751-IN002A-EN-P - March 2001
Prevent Electrostatic Discharge
Installing the 4-port Splitter Block
To install the 4-port splitter block:
1. Position the splitter block on a 35 x 7.5mm DIN rail (Allen-Bradley catalog
number 199-DR1) at a 30° angle.
ATTENTION
!
Electrostatic discharge can damage integrated circuits or
semiconductors if you touch backplane connector pins.
Follow these guidelines when you handle the splitter block:
•
Touch a grounded object to discharge static potential.
•
Wear an approved wrist-strap grounding device.
•
Do not touch the backplane connector or connector pins.
•
Do not touch circuit components inside the splitter block.
•
If available, use a static-safe work station.
•
When not in use, keep the splitter block in its static-shield
box.
31203a-M