Rockwell Automation 1747-PBASE BASIC Development Software Programming Manual - Manual (Page 48)

Publication 1746-PM001A-US-P
3-14 Configuring Your Software
Save Configuration and
Exit
Path: Toplevel Menu
→ → → →
Configuration menu
→ → → →
saVe configuration
and exit
Path: Main Menu
→ → → →
Config
→ → → →
saVe configuration and exit
Some configuration changes are saved immediately at the time you assign them,
while others are not saved until you select the
saVe configuration and exit
option from the Setup and Configuration menu. At that time, you are prompted
to save the configuration if changes have been made and were not saved previously.
If you elect to exit without saving configuration changes, those that were changed
immediately remain changed. Only changes that are not saved until exiting are
abandoned.
IMPORTANT
A file called DEFAULTS.BAT is included with the BASIC
Development Software package to restore the default values. It
will restore all values as if you had just installed the software in
your personal computer. This file is executed by typing
DEFAULTS
(while in the directory in which DEFAULTS.BAT is stored) prior
to running the BASIC Development Software.
ATTENTION
!
Executing the file DEFAULTS.BAT deletes all changes you made
to any of the BASIC Development Software parameters and
replaces them with the original default values. Do not execute
DEFAULTS.BAT from the DOS shell.