Rockwell Automation 1792-IB16 INSTL.INST ARMOR BLOCK 16 INPT User Manual
Page 30
ArmorBlock 16 Input Module
30
Publication 1792-5.3 – October 1996
6,
$ Link Path Size
”20 0F 24 03 30 01”,
$ Link Path to param instance. The param instance
$ decodes the enumerated parameter into engineering
$ units (micro seconds).
0x0002,
$ No support for settable path, scaling, scaling links,
$ or real time update of value. Value is gettable and
$ Settable. Enumerated strings are supported.
2,
$ Data Type – unsigned int
2,
$ Data Size – (in bytes)
”On–to–Off Delay”,
$ Parameter Name
”ms”,
$ Units String
$$$$$$$$$$ Help string $$$$$$$$$$$
”Signal must be present for this delay period before module detects the change.”,
0,4,0,
$ Min, Max (max enumeration #), and Default values
1,1,1,0,0,0,0,0,0;
$ Not Used
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
$$$$$$$$$$
Param4 =
$ Reset Faulted I/O
0,
$ reserved
6,
$ Link Path Size
”20 0F 24 04 30 01”,
$ Link Path to param instance.
0x0002,
$ No support for settable path, scaling, scaling links,
$ or real time update of value. Value is gettable and
$ Settable. Enumerated strings are supported.
8,
$ Data Type – unsigned short int
1,
$ Data Size – (in bytes)
”Reset Faulted I/O”,
$ Parameter Name
””,
$ Units String
$$$$$$$$$$ Help string $$$$$$$$$$$
”This resets the voltage supplied to sensors. A reset will only be accepted if a fault
exists.”,
0,1,0,
$ Min, Max (max enumeration #), and Default values
1,1,1,0,0,0,0,0,0;
$ Not Used
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
$$$$$$$$$$
Param5 =
$ Input 1 value
0,
$ reserved
6,
$ Link Path Size
”20 08 24 01 30 03”,
$ Link Path to Input 1 value attribute.
0x0030,
$ No support for settable path, scaling, or scaling links.
$ Value is gettable only. Enumerated strings are not
$ supported.
8,
$ Data Type – unsigned short int
1,
$ Data Size – (in bytes)
”Input 1 Value”,
$ Parameter Name
””,
$ Units String
$$$$$$$$$$ Help string $$$$$$$$$$$
”This parameter is the current value of Input 1.”,
0,1,0,
$ Min, Max, and Default values