Mount on a panel – Rockwell Automation 1790D-XXXX DeviceNet Digital Base D-Shell Module CompactBlock LDX I/O Series B User Manual
Page 8
8 DeviceNet Digital Base D-shell Block CompactBlock LDX I/O
Publication
1790-IN013A-EN-P - September 2006
Mount on a Panel
For panel mounting, use these steps.
Block Dimensions
1. Place the block against the panel where you want it mounted.
2. Gently pull and position the expansion cover to the left.
3. Place a center punch, nail, or similar device through the
mounting holes in the block and make two marks on the
panel at the lower-left and upper-right corners of the module.
4. Remove the block and drill two holes in the panel to
accommodate each of the mounting screws.
5. Replace the block on the panel and place a screw through
each of the two mounting holes.
6. Tighten the screws until the block is firmly in place.
44153
41 mm
(1.6 in.)
Expansion
Cover
95 mm
(3.74 in.)