Specifying a source key file – Rockwell Automation Logix5000 Controllers Security Programming Manual User Manual
Page 32
Advertising
Chapter 4 Configuring source protection in the Logix Designer application
Specifying a source key file
Follow these steps to configure a source key file location.
1. Open an offline project file.
2. On the menu bar, click Tools, then click Security, and then click
Configure Source Protection.
Tip:
This option is not available until you have run RS5KSrcPtc.exe on your workstation. See
Source protection requires that you specify a source key file location on your
workstation. You are prompted to specify a file location.
3. Click Yes.
4. In the Specify Source Key File Location dialog box, click the Browse
button.
32
Rockwell Automation Publication 1756-PM016G-EN-P - October 2014
Advertising