Rockwell Automation 1762-OW8 MICROLOGIX RELAY OUTPUT MODULE - Manual (Page 5)

MicroLogix 1762-OW8 Relay Output Module 5
Publication 1762-IN003B-EN-P - June 2013
Mounting
Minimum Spacing
Maintain spacing from
enclosure walls, wireways,
adjacent equipment, etc.
Allow 50.8 mm (2 in.) of
space on all sides for adequate
ventilation, as shown:
DIN Rail Mounting
The module can be mounted using the following DIN rails: 35 x 7.5 mm
(EN 50 022 - 35 x 7.5) or 35 x 15 mm (EN 50 022 - 35 x 15).
Before mounting the module on a DIN rail, close the DIN rail latch. Press the DIN rail
mounting area of the module against the DIN rail. The latch will momentarily open and lock
into place.
ATTENTION
!
Do not remove protective debris strip until after the module and all other
equipment near the module is mounted and wiring is complete. Once wiring is
complete and the module is free of debris, carefully remove protective debris
strip. Failure to remove strip before operating can cause overheating.
TIP
1762 expansion I/O may be mounted horizontally only.
ATTENTION
!
During panel or DIN rail mounting of all devices, be sure that all debris
(metal chips, wire strands, etc.) is kept from falling into the module. Debris
that falls into the module could cause damage when power is applied to the
module.
MicroLogix
1200
1762 I/O 1762 I/O 1762 I/O
Side Side
Top
Bottom