Rockwell Automation 1734-IT2I Thermocouple and RTD Input Module User Manual - Manual (Page 46)

Publication 1734-UM004F-EN-E - December 2012
36 Configure Your Module
Check I/O Status and View
the EDS File View the I/O defaults setup and the EDS file by clicking the appropriate tab.
1734-IT2I module
1. Click the I/O Defaults tab to
display the default
characteristics for this module.
This dialog shows the
input/output defaults for the
four modes:
Strobe
Polled
Change of state and
Cyclic
3. Click View File to view
the actual EDS file
(shown).
2. Click the EDS File tab to display the
statistics of the EDS file used to
configure this module.
You can view the actual
EDS file or edit the file.