Rockwell Automation 1769-ASCII Compact Module - Manual (Page 12)

12 Compact 1769-ASCII Module
Publication 1769-IN068B-EN-P - May 2005
6. Before installing the replacement module, be sure that the bus lever
on the module to be installed and on the right-side adjacent module
are in the unlocked (fully right) position.
7. Slide the replacement module into the open slot.
8. Connect the modules together by locking (fully left) the bus levers on
the replacement module and the right-side adjacent module.
9. Replace the mounting screws (or snap the module onto the DIN rail).
Ground the Module
This product is intended to be mounted to a well-grounded mounting surface
such as a metal panel. Additional grounding connections from the module’s
mounting tabs or DIN rail (if used) are not required unless the mounting
surface cannot be grounded. Refer to Industrial Automation Wiring and
Grounding Guidelines, publication 1770-4.1, for additional information.