Rockwell Automation 1792D-2BVA2D ArmorBlock MaXum 2 Input with Alarm/2 Output Module Series B - Manual (Page 7)

ArmorBlock MaXum 2 Input with Alarm/ 2 Output Module Series B 7
Publication 1792D-IN015B-EN-P - September 2000
I/O connectors for this module are shown below.
Output Power and DeviceNet Cables
Output power and DeviceNet cables are described in the installation
publications for the cable base of your choice. Refer to the following
publications:
• 1792D-IN009B-EN-P ArmorBlock MaXum Cable Base
Installation Guide
• DN-6.7.2 DeviceNet Cable Planning and Installation Manual
ATTENTION
!
• Make sure all connectors and caps are
securely tightened to properly seal the
connections against leaks and maintain
IP67 requirements.
• For maximum noise immunity, input and
output cable return wires must be properly
terminated. When inputs and outputs are
connected in loopback, return wires should
be connected together.
• I/O cable length should be less than 30
meters.
I0
A0
I1
A1
O0
O1
Auxiliary Power
Logic Status Net/Mod Status
41454
Input 0
Input A0
Input 1
Input A1
Output 0
Output 1
Connector A
Connector B
Connector C
Connector D