Rockwell Automation 1792D-16BVTOD ArmorBlock MaXum 16 Input Module Series B - Manual (Page 4)

4 ArmorBlock MaXum 16 Input Module Series B
Publication 1792D-IN016B-EN-P - September 2000
The module is equipped with AutoBaud detect. AutoBaud lets the
module read the settings already in use on your DeviceNet network
and automatically adjusts to follow those settings.
Install the Module
This module mounts to the following cable bases:
•
1792D-CBFM for KwikLink™ flat media installation
•
1792D-CB12 for 12mm drop cable installation
•
1792D-CB18 for round media trunk connection
•
or other optional cable base assembly
To install the module:
1. Position the module over the mounted cable base. Align the
three captive screws in the module with the accepting
receptacles in the base.
2. Tighten the screws to secure the module to the base.
IMPORTANT
The cable base should already be installed. See
publication 1792D-IN009B-EN-P for more
information on installing the cable base.
IMPORTANT
Proper alignment of the screws is necessary to
complete the connections between the module
contacts and the cable contacts.