Check the bat led – Rockwell Automation 1756-BATM ControlLogix Battery Module Installation Instructions User Manual
Page 19
Advertising
ControlLogix® Battery Module 19
Publication
1756-IN576B-EN-P - September 2003
Check the BAT LED
1. Turn on the chassis power.
2. Is the BAT LED off?
3. Check that the battery module is correctly connected to the controller.
4. Check that the battery assembly is correctly connected to the battery
module.
5. If the BAT LED remains on, install another battery assembly (catalog
# 1756-BATA).
6. If the BAT LED remains on after you complete step 5, contact your
Rockwell Automation representative or local distributor.
If:
Then:
Yes
The battery module is correctly installed.
No
Go to step 3.
31303-M
BAT LED
Advertising