Rockwell Automation 1756-BATM ControlLogix Battery Module Installation Instructions - Manual (Page 4)

4 ControlLogix® Battery Module
Publication 1756-IN576B-EN-P - September 2003
Equipment that You Need
The equipment that you need to install the battery module depends on how
you mount the module. You have these options:
• Mount the Battery Module Directly to a Panel
• Mount the Battery Module to a DIN Rail
Mount the Battery Module Directly to a Panel
To mount the battery module directly to a panel, you need the following
equipment:
• #2 phillips screwdriver
• drill
• screws and washers
Mount the Battery Module to a DIN Rail
To mount the battery module to a DIN rail, you need the following
equipment:
• #2 phillips screwdriver
For this: You need:
Quantity Description:
top mounting tabs 2 M4 or M5 (#10 or #12) phillips screw
2 flat washer
2 split lock washer
bottom mounting
tab 1 M4 or M5 (#10 or #12) phillips screw or SEM
screw (phillips screw with attached star
washer)
1 star washer (not required for SEM screws)