Rockwell Automation 1769-BOOLEAN Compact I/O BOOLEAN Module Installation Instructions - Manual (Page 6)

6
Publication 1769-IN077A-EN-P - May 2006
Install the 1769-BOOLEAN Module
Attach the module to the controller or an adjacent I/O module before or after mounting. For
mounting instructions, see Mount Module to Panel Using the Dimensional Template, or
Mount Module to DIN Rail. To work with a system that is already mounted, see Replace a
Single Module Within a System.
The following procedure shows you how to assemble the Compact I/O system.
1. Disconnect power.
2. Check that the bus lever of the module to be installed is in the unlocked (fully right)
position.
3. Use the upper and lower tongue-and-groove slots (1) to secure the modules together
(or to a controller).
4. Move the module back along the tongue-and-groove slots until the bus connectors (2)
line up with each other.
5. Push the bus lever back slightly to clear the positioning tab (3).
Use your fingers or a small screwdriver.
6. To allow communication between the controller and module, move the bus lever fully
to the left (4) until it clicks, making sure it is locked firmly in place.
ATTENTION
When attaching I/O modules, it is very important that the bus connectors
are securely locked together to be sure of proper electrical connection.
1
1 2
6
5
4
3
30536-M