Rockwell Automation 1792D-8BV0D ArmorBlock MaXum 8 Input Module with 8 Connectors, Series B I.I. - Manual (Page 5)

ArmorBlock MaXum 8 Input Module with 8 Connectors, Series B 5
Publication 1792D-IN051A-EN-P - February 2001
Note: Dimensions change according to the cable base and
module combination used.
Connect the Input Cord Sets to the MaXum Module
This module uses 5 pin micro (12mm) style PCB mounted connectors.
Eight micro caps cover the connectors on your module. Remove the
caps and connect your cord sets to the appropriate ports. This
product has two inputs per connector.
Use the micro caps to cover and seal unused ports. A pinout diagram
for the connectors is shown next.
Align the
screws to
properly
assemble the
module to the
base.
Cable Base 1792D-CBFM is
used for this example.
Assembled
dimensions in (mm)
1.9 (48.26)
2.7 (68.6)
6.85 (174mm)
42762
Input Micro-Connector
(View into Socket)
Pin 1 Sensor Source voltage
Pin 3 Return Logic Ground 1
Pin 4 Input A
Pin 5 Not Used
41452
1 Logic Ground is approximately 0.4V above DeviceNet V- measured at the module.