Rockwell Automation 1792D-8BV0D ArmorBlock MaXum 8 Input Module with 8 Connectors, Series B I.I. - Manual (Page 6)

6 ArmorBlock MaXum 8 Input Module with 8 Connectors, Series B
Publication 1792D-IN051A-EN-P - February 2001
Please refer to publication 889-CP001A-EN-P and 889-TD001A-EN-P
for Rockwell Automation cables and cord sets offerings.
I/O connectors for this module are shown below.
IMPORTANT
If the devices (sensors) connected to the input
connections require Class 2 power to operate, the
DeviceNet connections of this equipment must be
powered by a Class 2 source.
ATTENTION
ÿ
•
Make sure all connectors and caps are
securely tightened to properly seal the
connections against leaks and maintain IP67
requirements.
•
For maximum noise immunity, input cable
return wires must be properly terminated.
When inputs are connected in loopback,
return wires should be connected together.
•
I/O cable length should be less than 30
meters.
42763
Input 0
Input 1
Input 2
Input 3
Input 7
Input 6
Input 5
Input 4
Connector A
Connector B
Connector C
Connector D
Connector H
Connector G
Connector F
Connector E