Rockwell Automation 2706-DXX Dataliner Message Display DL5 Series - Manual (Page 19)

2706-UM001A-US-P
Getting Started 2-5
Then the DL5 displays the current run mode: (Numeric, Priority, Round
Robin, Binary or BCD) Finally, it will indicate it is entering the run mode
and display the AUTORUN message.
Note: The DL5 will always come up (after power down) in a run mode.
This will be the last run mode that the unit was in before power down. The
initial (out-of-the-box) default mode is numeric.
Press the [ESC] (Escape) key three times to exit the run mode. You will
then be shown the RUN? prompt.
Press [N] and [Retrn] and you will be shown the EDIT? prompt.
You are now ready to enter messages as described in the next chapter. But
first you should become familiar with the DL5’s prompts and main menu.
581"
(',7"