Rockwell Automation 6157 Industrial 20 inch Monitors - Manual (Page 22)

22 Industrial 20" CRT Monitor
Publication 6157-5.1
4. Remove each fuse by inserting the tip of a small flat-bladed
screwdriver between the fuse clip and the metal end cap of the fuse
and gently prying the fuse out of its clip.
5. Replace each fuse as required with a 5ST Slo-Blo type fuse rated at
2.5A, 250VAC.
6. After replacing each fuse in its clip holder, reinstall the plastic cover
over the fuses, reinstall the rear panel of the monitor, and reconnect
the AC power cord.
Note: If a fuse continues to blow, consult a qualified service
technician.
ATTENTION: To avoid danger of fire, always
replace the fuse with one of the same type and rating.
Replacing a Line Cord
To avoid shock and fire hazards, the monitor’s power cord should be
replaced if the insulation becomes broken or if it develops a loose
internal connection.
Other Maintenance
Qualified service personnel should perform all maintenance, except for
the fuse and power cord replacement described above.