Rockwell Automation 2711P-RDT12H High-bright Display Module - Manual (Page 11)

High-bright Display Modules 11
Publication 2711P-IN026E-EN-P - September 2008
Required Tools
These tools are required for installation:
•
Panel cutout tools
•
Small, slotted screwdriver
•
Torque wrench (lb • in)
Install the Terminal
Before installing the terminal in a panel, review these topics:
•
Mounting clearances
•
Panel cutout dimensions
•
Product dimensions
Mounting Clearances
Allow adequate clearance around the terminal, inside the enclosure, for adequate
ventilation. Consider heat produced by other devices in the enclosure. The ambient
temperature around the terminals must be between 0…55 °C (32…131 °F).
These minimum clearances are required for ventilation:
•
Top clearance: 51 mm (2 in.)
•
Bottom clearance: 102 mm (4 in.)
•
Side clearances: 25 mm (1 in.)
•
Back clearance: 25 mm (1 in.)
Minimum side clearance for insertion of memory card is 102 mm (4 in.).
Panel Cutout Dimensions
Use the full size template shipped with your terminal to mark the cutout
dimensions.
The 1250 Touch PanelView Plus and PanelView Plus CE Terminals are 257 mm
(10.11 in.) high and 338 mm (13.29 in.) wide.