Rockwell Automation 2711P-RDT12H High-bright Display Module - Manual (Page 13)

High-bright Display Modules 13
Publication 2711P-IN026E-EN-P - September 2008
4. Slide the ends of the mounting clips into the slots on the terminal.
5. Tighten the mounting clip screws by hand until the gasket seal contacts the
mounting surface uniformly.
6. Tighten the mounting clip screws to a torque of 0.90…1.1 N•m
(8…10 lb • in) by using the specified torque sequence, making sure not to
over-tighten.
ATTENTION Tighten the mounting clips to the specified torque to provide a proper seal and
prevent damage to the product. Rockwell Automation assumes no
responsibility for water or chemical damage to the product or other equipment
within the enclosure because of improper installation.
Mounting Clip Slot
Mounting Clip
4 Clips
1 4
3 2