Rockwell Automation 1797-OB4D FLEX Ex 24V DC Nonisolated Source 4 Output Module - Manual (Page 15)

FLEX Ex I/O 24V DC 4 Non-Isolated Source Output Module 15
Publication 1797-5.6 - June 2011
Specifications
General
Attribute Value
Number of outputs 4, nonisolated, sourcing
IS output type Ex ia IIB/IIC T4,
AEx ia IIC T4,
Class I, II, III Division 1 Groups A, B, C, D, E, F, G T4
IS module type Ex ib IIB/IIC T4,
AEx ib IIC T4,
Class I Division 1 Groups A…D T4
V-I Characteristics Refer to Output Voltage versus Current Capability on
page 29
Load range 30…5000 Ω
Fault detection Fault bits in data table and LED (per channel)
blinking red (1 Hz)
Electronic protection Lead break, overload, short circuit
Maximum output delay times
OFF to ON
ON to OFF
<1.2 ms
<1.2 ms
Indicators 4 yellow status indicators
4 red fault indicators
1 green module power indicator
Output (intrinsically safe)
(16 pin male and female
FlexBus connector)
U
i
< 5.8V DC
I
i
< 400 mA
L
i
= Negligible
C
i
< 1.35 μF
Isolation path
Output to power supply
Output to FlexBus
Power supply to FlexBus
Output to output
Isolation type
Galvanic to DIN EN 60079-11
Galvanic to DIN EN 60079-11
Galvanic to DIN EN 60079-11
None