Rockwell Automation 2094-xxxx Kinetix 6200 and Kinetix 6500 Control Module Installation Instructions - Manual (Page 4)

4 Kinetix 6200 and Kinetix 6500 Control Modules
Rockwell Automation Publication 2094-IN012C-EN-P - August 2013
Install the Control Modules
The IAM and AM power modules are equipped with two mounting hooks and a threaded hole.
The Bulletin 2094 control modules have two mounting studs, guide pins, and a captive screw for
mating the control module with a power module.
Follow these steps to mount Bulletin 2094 control modules to IAM (inverter) power module or
AM power modules. In this procedure an IAM power module is shown.
1. Remove all input power from the IAM power module.
Verify that the Power-applied indicator is off. When the indicator is on, voltage is
present on the IAM and AM power module signal connectors.
2. Position the control module in front of the power module.
IMPORTANT For convenience and ease of use, mount the IAM and AM power modules on the power rail
before mounting the control modules.
When the IAM power modules are placed on a flat surface, with the power-rail connectors
facing down, the mounting screw that extends from the front of the drive and fastens to the
power rail, pushes back and interferes with the control module installation.
Refer to the Kinetix 6200 and Kinetix 6500 IAM and AM Power Modules Installation
Instructions, publication
2094-IN011 , for more information.
ATTENTION: To avoid damage to equipment, do not mount your Bulletin 2094 control
module to the power module when the Power-applied indicator is on. Remove all
input power from the IAM power module before mounting the control module.
IAM or AM Power Module
(IAM power module is shown)
Captive
Screw
Bulletin 2094 Control Module
(Kinetix 6200 control
module is shown)
Threaded Hole
in Tongue
Mounting Hooks
Mounting Studs
(other mounting stud is hidden from view)
Guide Pins
Signal Connectors
Power-applied Indicator