Rockwell Automation 6159 Industrial 17 inch CRT Monitors, Series B - Manual (Page 15)

Industrial 17" CRT Monitor 15
Publication 6159-5.1
Connecting AC Power
The 6159 Industrial Monitor requires a single phase power supply
providing 100 to 240V AC at 50 or 60 Hz. Power must be available at a
grounded three-pin outlet located nearby. Whenever possible, connect
the monitor to the same AC source that supplies the computer.
To connect AC power to the monitor:
1. Turn off the main switch or breaker.
2. Use the ground terminal of the monitor to establish a chassis-to-earth
ground connection. Secure one end of a ground strap to the ground
terminal. Connect the other end of the ground strap to a good earth
ground.
The ground terminal is an M5 screw.
ATTENTION: Chassis ground must be connected for
safe operation of the monitor. The AC receptacle on the
monitor is a 3-wire type with chassis ground pin, and the
mating AC cord supplied is a 3-wire type, designed for
connection to a grounded 3-pin AC outlet. However, a
properly ground AC outlet is not always available, and
grounding using a 3-wire cord can easily be defeated. If
you fail to ground the monitor properly, the setup may
result in personal injury from electrical shock or damage
to the equipment.
3. Connect the socket end of the AC power cord to the mating
connector on the rear panel of the monitor.
4. Connect the plug end of the AC power cord to the main outlet.
5. Restore AC power to the outlet.