Message prompting – Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C-Frame) - ForGe Control User Manual
Page 134
134
Rockwell Automation Publication 7000L-UM301D-EN-P - June 2014
Chapter 3
Operator Interface
Message Prompting
All the changes you made while you were configuring the drive are stored in
volatile memory of the drive. This means that when power to the drive is lost, so
will be the changes. To permanently store the changes, the contents of the
memory must be stored to NVRAM memory.
When you exit a group of screens on which you have changed the drive data, you
will be prompted as in
to save the data. If you wish to save the data,
press [F8] 'Yes' and the NVRAM screen (refer to
) will be entered (
). If you wish the data to
reside as temporary data in RAM only, press [F9] 'No'. Pressing [F10] Exit will
return you to the screen from which you previously exited.
Note that the data can still be saved at a later time by accessing the NVRAM
screen directly from the Top Level Menu. Refer to
.
Figure 133 - Message Prompt Screen
Figure 134 - NVRAM Screen